Current Issue

Mesin Vol. 13 Issue 2 1998

Vol. 13 No. 2 (1998)

Issue Articles

Articles Published in This Issue

Explore peer-reviewed research articles published in this issue.

Article

Korelasi Kesetimbangan Fasa Sistem Co2-c2h5oh Pada Kondisi Subkritik

This paper concerns with the correlation of phase equilibrium of binary system of carbon dioxide-ethanol at subcritical and supercritical condition. In this study, three equations of state(Redlich-Kwong, Soave-Redlich-Kwong, and Peng-Robinson) together with conventional mixing rule, were applied for correlating phase equilibrium the system. The capabilities of these equations of state were examined with experiment results obtained from the literatures. The results show that Soave-Redlich-Kwong and Peng-Robinsoh equations of states can well correlate the phase equilibrium of binary system of…

DOI
Keywords
0 Views0 Downloads0 Citations
Article

Pengaruh Arah Serat Dan Susunan Lapisan Terhadap Faktor Konsentrasi Tegangan Pada Komposit Laminate Carboniepoxy As4/3501-6 Berluban G Lin Gkaran Dan Ellips

In recent years, fiber-matrix composite laminates have been widely used in mechanical structures. Due to functional design requirements, the laminates may contain holes that could cause stress concentration. Unlike isotropic plate, where the stress concentration depend upon geometric parameter and loading conditions, stress concentration factor of fiber-matrix composite is also depend on the anisotropic properties such as fiber direction and angle ply. This paper present intensive studies of the influence of the fiber direction and angle ply to the stress concentration factors for…

DOI
Keywords
0 Views0 Downloads0 Citations
Article

Pembuatan Dan Pengujian Anemometer Kawat Panas Temperatur Konstan Untuk Pengukuran Kecepatan Udara Pada Aliran Swirling

To overcome the difficulties in calibrating a hot wire anemometer the equation E2 = A+BU0.45, as the reference equation in making hot wire anemometer, was changed to U = (1/ B (E2-A))2.22 to produce linear calibration curve. To realize this idea then an electronic circuit was designed with IC AD 534 and AD 538 as the main components. IThe hot-wire anemometer was made based upon the above principles then used to measure velocity components of swirling flow, which has two components of velocity, i.e.: axial (normal) velocity and tangential velocity. In measurement of swirling flow the probe-X…

DOI
Keywords
0 Views0 Downloads0 Citations

No articles match the selected filter or search query.